User guide

76 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Print Engine Configuration
Front Panel LCD
ZebraNet
®
Print Server LCD Displays
The menu options shown in Table 7 display only if you have the ZebraNet 10/100 PrintServer
or Wireless Print Server installed.
Table 7 • Print Server LCD Displays
Parameter Action/Explanation
Load LAN Source
1
This parameter, which serves the same function as the ^NP ZPL
command, specifies whether to use the printer’s or the print server’s IP
settings at bootup.
• Press the right or left oval to display other choices.
Default: PRINTER
Selections: PRINTER, PRINTSERVER
Wired PrintServer Check
1
This parameter, which serves the same function as the ^NB ZPL
command, tells the printer whether to search for a wired print server at
bootup.
• Press the right or left oval to display other choices.
Default: NO
Selections: YES, NO
IP Protocol
2
Allows either the user (permanent) or the server (dynamic) to select the
IP address. If a dynamic option is chosen, this selection determines the
method(s) by which the print server (wired or wireless) receives the IP
address from the server.
• Press the right or left oval to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP AND BOOTP, PERMANENT
Note • Use of GLEANING ONLY is not recommended when the
Wireless Print Server is installed.
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults
to address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
LOAD LAN FROM?
PRINTER
WIRED PS CHECK?
NO
IP PROTOCOL
ALL