User guide

74 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Print Engine Configuration
Front Panel LCD
Select Format Convert
Selects the bitmap scaling factor. The first number is the original dots per
inch (dpi) value; the second, the dpi to which you would like to scale.
• Press the right or left oval to display other choices.
Default: NONE
Selections:
NONE, 150 → 300, 150 → 600, 200 → 600, 300 → 600
Set RTS Takeup Dancer Arm Calibration Value
This parameter is used as a diagnostic tool to monitor the voltage supplied
to the Ribbon Tensioning System Takeup Dancer Arm. Refer to the
Maintenance Manual for information.
Set RTS Supply Dancer Arm Calibration Value
This parameter is used as a diagnostic tool to monitor the voltage supplied
to the Ribbon Tensioning System Supply Dancer Arm. Refer to the
Maintenance Manual for information.
Select Idle Display
This parameter selects the LCD options for the real-time clock.
Note • If the default value is not selected, pressing either oval
briefly displays the firmware version of the print engine.
• Press the right or left oval to display other choices.
Default: FIRMWARE VERSION
Selections: MM/DD/YY (24 HOUR), MM/DD/YY (12 HOUR),
DD/MM/YY (24 HOUR), DD/MM/YY (12 HOUR), FW VERSION
Set RTC Date
This parameter allows you to set the date following the convention
selected in
IDLE DISPLAY.
1. Press the left oval to move to the next digit position.
2. Press the right oval to change the value of the digit.
Table 6 • Print Engine Parameters (Sheet 18 of 19)
Parameter Action/Explanation
FORMAT CONVERT
- NONE +
RTS TAKEUP ARM
XXX
RTS SUPPLY ARM
XXX
IDLE DISPLAY
- FW VERSION +
RTC DATE
- 01/31/01 +