User guide

Print Engine Configuration
Front Panel LCD
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 73
Set Reprint Mode
When the Reprint feature is enabled, the reprint input signal (Pin 6) on the
applicator port is functional. When the input signal is asserted, the last
label printed is printed again. (This includes non-printing labels.) When
the Reprint feature is disabled, the reprint input signal is ignored.
Note • The ^SP ZPL command is ignored when the Reprint
feature is enabled. When the Reprint feature is disabled, the
^SP
command can be used. In addition, when a received label format
is canceled prior to printing, the reprint function for the previous
label is also canceled. Refer to the ZPL II Programming Guide
for additional information.
• Press the right or left oval to display other choices.
Default: DISABLED
Range: ENABLED, DISABLED
These parameters are automatically set during the calibration procedure
and should be changed only by a qualified service technician. Refer to the
ZPL II Programming Guide for information on these parameters.
• Press
NEXT repeatedly to skip these parameters.
Adjust LCD Display
This parameter allows you to adjust the brightness of your LCD if it is
difficult to read.
• Press the left oval to decrease the value (reduce brightness).
• Press the right oval to increase the value (increase brightness).
Default: 10
Range: 00 to 19
Table 6 • Print Engine Parameters (Sheet 17 of 19)
Parameter Action/Explanation
REPRINT MODE
- DISABLED +
WEB S. 073
- +
MEDIA S. 075
- +
RIBBON S. 071
- +
MARK S. 000
- +
MARK MED S. 000
- +
MEDIA LED 082
- +
MARK LED 005
- +
RIBBON LED 008
- +
LCD ADJUST +10
- +