User guide

Print Engine Configuration
Front Panel LCD
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 71
Set the Head Resistor Value
Caution • This parameter should be changed only by qualified service
personnel. Do not set the value higher than that shown on the
printhead. Setting a higher value may damage the printhead.
This value has been preset at the factory to match the resistance value of
the printhead. It does not need to be changed unless the printhead or the
main logic board is replaced.
1. Look on the printhead for the label that shows the resistance value
(
Ω value). Take note of this value before installing the replacement
printhead.
2. Press the left oval to move to the next digit position.
3. Press the right oval to increase the value of the digit.
Initial Value: Factory-set to match the printhead shipped with your print
engine.
Default Value: 0500
Range: 0500 to 2000
Set the Applicator Port
Determines the action of the applicator port.
Note • Set this value as suggested by the applicator manufacturer.
• Off: The applicator port is off.
• Mode 1: Asserts the ~END_PRINT signal low while the print
engine is moving the label forward.
• Mode 2: Asserts the ~END_PRINT signal high while the print
engine is moving the label forward.
• Mode 3: Asserts the ~END_PRINT signal low for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
• Mode 4: Asserts the ~END_PRINT signal high for 20 milliseconds
when a label has been completed and positioned. Not asserted during
continuous printing modes.
• Press the right or left oval to display other choices.
Default: OFF
Selections: OFF, MODE 1, MODE 2, MODE 3, MODE 4
Table 6 • Print Engine Parameters (Sheet 15 of 19)
Parameter Action/Explanation
HEAD RESISTOR
- 0500 OHMS +
APPLICATOR PORT
- OFF +