User guide

70 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Print Engine Configuration
Front Panel LCD
Select Backfeed Sequence
This parameter establishes when label backfeed occurs after a label is
removed in applicator mode. It has no effect in Rewind mode. This
parameter setting can be superseded by the
~JS instruction when received
as part of a label format (refer to ZPL II Programming Guide Volume I).
• Press the right or left oval to display other choices.
Default: BEFORE
Selections: DEFAULT, AFTER, BEFORE, OFF
Adjust Label Top Position
The label top position adjusts the print position vertically on the label.
Positive numbers adjust the label top position further down the label (away
from the printhead); negative numbers adjust the position up the label
(toward the printhead). The displayed value represents dots.
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: +000
Range: –120 to +120 dots
Adjust Left Position
This parameter establishes how far from the left edge of a label the format
begins to print by adjusting horizontal positioning on the label. Positive
numbers adjust the printing away from the main frame by the number of
dots selected; negative numbers shift printing toward the main frame. The
displayed value represents dots.
1. Press the left oval to move the cursor.
2. Press the right oval to change between + and to increase the value of
the digit.
3. For a negative value, enter the value before changing to the minus
sign.
Default: 0000
Range: –9999 to +9999 dots
Table 6 • Print Engine Parameters (Sheet 14 of 19)
Parameter Action/Explanation
BACKFEED
- BEFORE +
LABEL TOP +000
- +
LEFT POSITION
- ±0000 +