User guide

Print Engine Configuration
Front Panel LCD
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 69
Select ZPL Mode
The print engine remains in the selected mode until it is changed by this
front panel instruction or by using a ZPL/ZPL II command. The print
engine accepts label formats written in either ZPL or ZPL II, eliminating
the need to rewrite any ZPL formats that already exist. See the ZPL II
Programming Guide for more information on the differences between ZPL
and ZPL II.
• Press the right or left oval to display other choices.
Default: ZPL II
Selections: ZPL II, ZPL
Select Media Power-Up Option
This parameter sets the action of the labels when the print engine is turned
on.
• Press the right or left oval to display the choices.
Default: CALIBRATION
Selections: FEED, CALIBRATION, LENGTH, SHORT CAL, and NO
MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the sensor
settings.
• Length—In continuous mode, feeds the last stored label length. In
non-continuous mode, calibrates based on the maximum label length
setting (see Set Maximum Label Length on page 60).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to cause
the print engine to resynch to the start of the next label.
Select Head Close Option
• Press the right or left oval to display the choices.
Default: CALIBRATION
Selections: FEED, CALIBRATION, LENGTH, SHORT CAL, and NO
MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the sensor
settings.
• Length—In continuous mode, feeds the last stored label length. In
non-continuous mode, calibrates based on the maximum label length
setting (see Set Maximum Label Length on page 60).
• Short Cal—calibrates label length using the current sensor settings.
• No Motion—the media does not move. You must press
FEED to cause
the print engine to resynch to the start of the next label.
Table 6 • Print Engine Parameters (Sheet 13 of 19)
Parameter Action/Explanation
ZPL MODE
- ZPL II +
MEDIA POWER UP
- CALIBRATION +
HEAD CLOSE
- CALIBRATION +