User guide

60 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Print Engine Configuration
Front Panel LCD
Set Maximum Label Length
This parameter is used during the media portion of the calibration process.
Always set maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length (Figure 38). If the value is
set to a smaller value than the label length, the print engine assumes that
continuous media is loaded, and the print engine cannot calibrate.
For example, if the label length is 5.0 inches (126 mm) including the
interlabel gap, set the parameter for 6.0 inches (152 mm). If the label
length is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: 39.0 inches (988 mm).
Range: Values are adjustable in one-inch (25.4 mm) increments.
Figure 38 • Label Length
Table 6 • Print Engine Parameters (Sheet 4 of 19)
Parameter Action/Explanation
MAXIMUM LENGTH
-39.0 IN 988 MM
}
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set maximum label length to approximately
this value
1
3