User guide

Print Engine Configuration
Overview
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 53
Exit Setup Mode
To leave Setup mode, complete these steps:
1. Press SETUP/EXIT.
The LCD displays SAVE CHANGES.
2. Press the left or right oval to display the save options (Table 5).
3. Press NEXT to select the displayed choice.
When the configuration and calibration sequence is done,
PRINTER READY displays.
Table 5 • Save Options When Leaving Setup Mode
LCD Description
PERMANENT
Stores values in the print engine even when power is turned
off.
TEMPORARY
Saves the changes until power is turned off.
CANCEL
Cancels all changes made since you entered Setup mode,
except for changes made to the darkness and tear-off settings,
which go into effect as soon as they are made.
LOAD DEFAULTS
Restores all parameters other than the network settings back
to the factory defaults.
Note • Loading factory defaults causes the print engine to
auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Restores the wired and wireless network settings back to
factory defaults.