User guide

38 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Print Engine Operation
Load Media
8. See Figure 24. Position the media so that it is aligned with and just touching the inner
media guide.
9. See Figure 24. Under the print engine, grasp the brass thumb nut of the outer media guide,
and position the outer media guide so that it just touches the outer edge of the media.
Figure 24 • Adjusting the Outer Media Guide
10. See Figure 19 on page 34. Press down on the pinch roller assembly until it locks closed.
11. See Figure 22 on page 36. Close the printhead assembly by rotating the printhead latch
until it latches onto the locking pin.
12. See Figure 25. Raise the peel roller latch so that the peel roller assembly pivots downward.
Figure 25 • Releasing the Peel Roller Assembly
1
Outer media guide
2
Media
1
Peel roller latch
2
Peel roller assembly
2
1
1
2