User guide

Getting Started

Connect the Print Engine to a Power Source

57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 21

Connect the Print Engine to a Power Source

The power supply in the print engine automatically detects the applied line voltage and works

in the 90 to 264 VAC, 48 to 62 Hz range.

Refer to Figure 10. The AC power cord must have a three-prong female connector on one end

that plugs into the mating AC power connector at the rear of the print engine. If a power cable

was not included with your print engine, refer to Power Cord Specifications on page 22.

To connect the print engine to a power source, complete these steps:

1. Turn Off (O) the print engine power switch (located on the top of the print engine

housing).

2. Plug the power cord into the AC power connector on the rear of the print engine.

Figure 10 • Power Connection

3. Plug the other end of the power cord into the power source.

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use

an IEC 320 female connector and the appropriate region-specific three-conductor

grounded plug configuration.

Left-Hand Right-Hand

AC power connector