User guide

20 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1

Getting Started

Print Engine Installation

Install the Print Engine in an Applicator

This section provides the basic instructions for installing the print engine into an applicator.

To install the print engine into an applicator, complete these steps:

1. See Figure 9. Install the center mounting bolt into the center hole on the applicator.

2. Carefully place the keyhole on the center mounting bolt.

3. Install the four corner mounting screws to secure the print engine to the applicator.

Figure 9 • Front View of 170PAX4 Print Engine in Applicator

Caution • If the print engine is installed improperly, it could fall out of the applicator and

cause injury. The center mounting bolt and four mounting screws must be installed and

secured. See Figure 9 for the location of the bolt and screws.

Note • The keyhole and the center mounting bolt are designed to support the print engine

and assist in installing and removing the four mounting screws.

Mounting screws (four total)

Keyhole

Center mounting bolt (shown inside hole on applicator)

Applicator