User guide

106 170PAX 4 User Guide 10/12/2004 57516L-001 Rev. 1
Troubleshooting
Print Engine Diagnostics
Communications Diagnostics Test
Do not perform the following test until all configuration and calibration parameters have been
set. For configuration information, see Front Panel LCD on page 57.
This test is controlled from the front panel display. See Set Communications Mode on page 67.
Figure 51 shows a typical printout from this test. Turn off the power to exit this self test and
return to normal operation.
Figure 51 • Communications Diagnostics Test Label
B:Memory Fixed (option card)
J12 Interface Fixed
J11 Interface Fixed
J10 Interface Fixed
J9 Interface Fixed
J8 Interface Fixed
J7 Interface Fixed
Table 14 • Control of Print Engine Parameters
Parameter Controlled By
Note • The communications test label prints upside-down.