User guide

Troubleshooting
Print Engine Diagnostics
57516L-001 Rev. 1 10/12/2004 170PAX4 User Guide 105
Delimiter Character Configuration, ZPL, and WebView
ZPL Mode Configuration, ZPL, and WebView
Media Power Up Configuration, ZPL, and WebView
Head Close Configuration, ZPL, and WebView
Backfeed Configuration, ZPL, and WebView
Label Top Configuration, ZPL, and WebView
Left Position Configuration, ZPL, and WebView
Head Resistance Configuration (must match head resistance label value), ZPL, and
WebView
Verifier Port Configuration, ZPL, and WebView
Applicator Port Configuration, ZPL, and WebView
Start Print Signal Configuration, ZPL, and WebView
Resynch Mode Configuration, ZPL, and WebView
Ribbon Low Mode Configuration, ZPL, and WebView
Reprint Mode Configuration, ZPL, and WebView
Web Sensor Configuration, ZPL, and WebView
Media Sensor Configuration, ZPL, and WebView
Ribbon Sensor Configuration, ZPL, and WebView
Mark Sensor Configuration, ZPL, and WebView
Mark Media Sensor Configuration, ZPL, and WebView
Media LED Configuration, ZPL, and WebView
Ribbon LED Configuration, ZPL, and WebView
Mark LED Configuration, ZPL, and WebView
LCD Adjust Configuration and WebView
Modes Enabled ZPL and WebView
Modes Disabled ZPL and WebView
Resolution Fixed (head type switch)
Socket 1 ID Fixed (option EPROMS)
Firmware Fixed (code EPROMS)
Configuration Configuration and WebView
Memory Fixed (SIMM size and 1 MB standard)
Table 14 • Control of Print Engine Parameters
Parameter Controlled By