User guide

Front Panel Controls
Overview
13383L-001 Rev. 1 7/8/2004 XiIIIPlus User Guide 55
Exit Setup Mode
To leave Setup Mode, complete these steps:
1. Press SETUP/EXIT.
The LCD displays SAVE CHANGES .
2. Press the left or right oval to display the save options (Table 4).
3. Press NEXT/SAVE to select the displayed choice.
When the configuration and calibration sequence is done, PRINTER READY displays.
Table 4 • Save Options When Leaving Setup Mode
LCD Display Description
PERMANENT
Permanently saves the changes. Values are stored in the printer even when power
is turned off.
TEMPORARY
Saves the changes until you change them again or until power is turned off.
CANCEL
Cancels all changes from the time you pressed SETUP/EXIT except the
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS
Sets all parameters other than the network settings back to the factory defaults.
To see the factory default values, see Front Panel LCD on page 57.
Note • Loading factory defaults causes the printer to auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Sets the wired and wireless network settings back to factory defaults.