User guide

54 XiIIIPlus User Guide 13383L-001 Rev. 1 7/8/2004

Front Panel Controls

Overview

After you have installed media and ribbon and printed a configuration label, you can change

the printer’s settings using the front panel controls. For an overview of the front panel,

including descriptions of the buttons and lights, see Front Panel on page 3. If you need to

restore the printer to its factory default settings, see FEED and PAUSE Self Test on page 117.

Many printer settings may be controlled by your printer’s driver or label preparation software.

Refer to the driver or software documentation for more information.

Enter Setup Mode

To enter Setup Mode, complete these steps:

1. Press SETUP/EXIT to enter Setup Mode.

2. Press either NEXT/SAVE or PREVIOUS to scroll through the parameters.

Note • Printers that are operating on an IP network can be quickly configured in the following

ways:

• with ZebraLink™ WebView (ZebraNet

PrintServer II or 10/100 Print Server required).

For information, see the ZebraNet Networking: PrintServer II Installation and User Guide

or the ZebraNet 10/100 Print Server User and Reference Guide.

• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For

information, see the ZebraNet Wireless Print Server User Guide.