User guide

Print Modes and Options
Print Modes
13383L-001 Rev. 1 7/8/2004 XiIIIPlus User Guide 49
Rewind Mode with Cutter Option
Printers with the Cutter option can use the Rewind mode to print and save a roll of labels
(Figure 34). See www.zebra.com for more information about the Cutter option.
Figure 34 • Media Loaded in Rewind Mode with Cutter Option
To set up the Rewind Mode for printers with the cutter option, complete
these steps:
1. Turn the printer On (I).
The printer feeds out and cuts one label.
2. From the front panel, select Rewind Mode.
3. Remove the rewind plate from its storage location in front of the print mechanism inside
the media compartment.
4. Invert the rewind plate so that the lip on the attached hook plate points down.
Note • Rewind mode cannot be used with the Cutter option on 110XiIIIPlus printers.
1
Printhead lever
2
Media guide
3
Media supply guide
4
Labels
5
Guide plate
6
Spindle hook
7
Rewind spindle
8
Rewind plate for Rewind Mode with Cutter option
9
Printed label
10
Cutter
1
2 3
4
7 6
5
8
9
10