User guide

Print Modes and Options
Print Modes
13383L-001 Rev. 1 7/8/2004 XiIIIPlus User Guide 43
9. Adjust the media supply guide so it is just touching the edge of the media.
10. When loading labels, allow approximately 36 in. (915 mm) of labels to extend past the
tear-off/peel-off bar. Remove all labels from this portion to create a leader.
11. Remove the hook from the rewind spindle. If you are using a core, slide it onto the rewind
spindle until it is flush against the guide plate.
12. Wind the label backing around either the 3 in. (76 mm) core or the rewind spindle and
reinstall the hook.
13. Flip up the media supply guide. Slide in the media guide and media supply guide so they
just touch, the edge of the labels. The labels should lie flat.
14. Before closing the printhead, make sure that:
• The labels are positioned against the inside guides.
• The labels are taut and parallel with the pathway when wound onto the rewind spindle
or core.
15. Close the printhead.
The backing winds on the rewind spindle or core.
16. For instructions for removing the backing from the rewind spindle, see Remove Backing
or Labels from Rewind Spindle on page 51.