User guide

42 XiIIIPlus User Guide 13383L-001 Rev. 1 7/8/2004
Print Modes and Options
Print Modes
Peel-Off Mode
Peel-Off Mode (Figure 30) advances one label at a time. The printer does not print another
label until the first label is removed. The TAKE LABEL light flashes until the label is
removed. The backing is wound on the rewind spindle, but the rewind plate is not used.
Figure 30 • Media Loaded in Peel-Off Mode
To set up the printer in Peel-Off Mode, complete these steps:
1. Remove the rewind plate (if installed) from the front of the printer. Store it on the two
mounting screws on the inside of the front panel.
2. From the front panel, select Peel-Off Mode.
3. Open the printhead.
4. Slide the media guide and media supply guide as far from the printer frame as possible.
5. Flip down the media supply guide.
6. Put the roll of media on the media hanger.
7. Push the label core toward the printer frame. The labels must be aligned with the label
core.
8. Feed the media under the media guide roller and under the printhead.
1
Printhead lever
2
Media guide
3
Media supply guide
4
Media
5
Guide plate
6
Spindle hook
7
Rewind spindle
8
Label backing
9
Tear-off bar
10
Printed label
1
2
3
4
7 6
5
8
9
10