User guide

Index
13383L-001 Rev. 1 7/8/2004 XiIIIPlus User Guide 137
printer settings (continued)
head resistor, 70
head test count, 69
host handshake, 64
idle display, 72
IP settings, 73
label top, 68
labels per roll, 60
language, 72
LCD, 72
left position, 68
maximum label length, 59
media type, 58
network configuration label as baseline, 31
network ID, 65
parallel communications, 63
parity, 64
passwords, 56
print darkness, 57
print method, 58
print server settings, 73
print speed, 57
print width, 59
protocol, 64
resynch mode, 71
ribbon length, 60
saving, 55
sensor type, 58
serial communications, 63
setting through front panel, 54
start print signal, 71
time, 72
verifier port, 70
ZPL mode, 66
printer setup
before you begin, 8
load the printer, 20
printhead
cleaning, 93
early warning message, 60
head close setting, 67
head resistor value setting, 70
head test count setting, 69
pressure adjustment, 37
when to clean, 92
product improvements, v
proprietary statement, v
protocol setting, 64
R
related documents, xx
relative humidity requirements, 10
remove backing from rewind spindle, 51
remove used ribbon, 28
replace fuse, 100
report shipping damage, 9
reset network option, 74
reship the printer, 9
resynch mode setting, 71
Rewind Mode, 46
Rewind Mode with Cutter option, 49
rewind plate installation, 46
rewind spindle, 51
RFID-ready printers
cleaning the snap plate, 98
RFID-ready option, 40
ribbon
adhesive test, 17
CHECK RIBBON light on, 33
create ribbon leader, 24
determining coated side, 16
load, 24
removal, 28
RIBBON IN message, 106
ribbon LED setting, 71
ribbon low warning, 60
Ribbon Out message, 105
scratch test, 17
setting length, 60
specifications, 126
troubleshooting wrinkles, 110
when to use, 16
Ribbon S. setting, 71
ribbon sensor
calibration procedure, 63
cleaning, 95
location, 95
sensitivity calibration, 32
when to clean, 92
roll media loading, 20
routine maintenance, 91
RS-232 interface connections, 80
RS-422/RS-485 interconnections, 82
RTC (Real-time clock) setting
date, 72
time, 72