User guide

128 XiIIIPlus User Guide 13383L-001 Rev. 1 7/8/2004
Specifications
Label Specifications
Label Specifications
XiIIIPlus printers need the correct size and type of labels for best performance. Refer to the
tables that follow for the specifications.
110XiIIIPlus Printers
Label Specification Key This table contains the key for the label modes, dimensions, and
directions:
Important • Media registration and minimum label length are affected by label type and
width, ribbon type, print speed, and printer mode of operation. Performance improves as these
factors are optimized. Zebra recommends qualifying any application with thorough testing.
T Tear-Off  Minimum
P Peel-Off  Maximum
C Cutter  Preferred
R Rewind
Label Specifications 110XiIIIPlus 200 dpi 110XiIIIPlus 300 dpi 110XiIIIPlus 600 dpi
Minimum label length 0.7 in. (18 mm) T 0.7 in. (18 mm) T 0.7 in. (18 mm) T
0.5 in. (13 mm) P 0.5 in. (13 mm) P 0.5 in. (13 mm) P
1.5 in. (38 mm) C 1.5 in. (38 mm) C 1.5 in. (38 mm) C
0.25 in. (6 mm) R 0.25 in. (6 mm) R 0.25 in. (6 mm) R
Total media width (label +
backing, if any)
0.79 in. (20 mm)
4.5 in. (114 mm)
0.79 in. (20 mm)
4.5 in. (114 mm)
0.79 in. (20 mm)
4.5 in. (114 mm)
Total thickness (includes
backing, if any)
0.003 in. (0.076 mm)
0.012 in. (0.305 mm)
0.003 in. (0.076 mm)
0.012 in. (0.305 mm)
0.003 in. (0.076 mm)
0.012 in. (0.305 mm)
Cutter maximum full-
width media thickness
0.009 in. (0.23 mm) 0.009 in. (0.23 mm) 0.009 in. (0.23 mm)
Roll media core inside
diameter
3 in. (76 mm) 3 in. (76 mm) 3 in. (76 mm)
Maximum roll diameter on
3in. (76mm) core
8.0 in. (203 mm) 8.0 in. (203 mm) 8.0 in. (203 mm)
Interlabel gap 0.079 in. (2 mm)
0.118 in. (3 mm)
0.079 in. (2 mm)
0.118 in. (3 mm)
0.079 in. (2 mm)
0.118 in. (3 mm)
Maximum interlabel gap No more than the
calibrated length of the
label.
No more than the
calibrated length of the
label.
No more than the
calibrated length of the
label.