User guide

98 XiIIIPlus User Guide 13383L-001 Rev. 1 7/8/2004
Routine Maintenance
Clean Interior
7. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into the two
slots of the media path.
8. Slide the snap plate toward you.
9. Press down on the loops to lock the snap plate into place.
RFID-Ready Printers
Figure 51 • Snap Plate for RFID-Ready XiIIIPlus Printers
To clean the snap plate in an RFID-ready printer, complete these steps:
1. Remove the two screws that secure the snap plate to the antenna support frame.
2. Remove the snap plate from the printer.
3. Clean the snap plate with cleaning solvent and a soft cloth.
4. To reinstall the snap plate, slide it back into place until the screw holes on the snap plate
line up with the screw holes in the antenna support frame.
5. Reinstall the two snap plate screws to secure the snap plate to the antenna support frame.
1
Antenna support screws
2
Location of right-side snap plate screw
(screw not shown)
3
Snap plate
4
Antenna support
5
Antenna support frame
6
Left-side snap plate screw
1
6
5
2
4
3
Important • Do not remove the antenna support screws.