User guide

Configuration
Control Panel Parameters
88
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Set RTS Supply Dancer Arm Calibration Value
This parameter is used as a diagnostic tool to monitor the voltage supplied
to the Ribbon Tensioning System Supply Dancer Arm. Refer to the
Maintenance Manual for information.
Select Idle Display
This parameter selects the LCD options for the real-time clock.
Note • If the default value is not selected, pressing the left or right
oval briefly displays the firmware version of the print engine.
Default: FIRMWARE VERSION
Selections: MM/DD/YY (24 HOUR), MM/DD/YY (12 HOUR),
DD/MM/YY (24 HOUR), DD/MM/YY (12 HOUR), FW VERSION
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Real-Time Clock (RTC) Date
This parameter allows you to set the date following the convention selected
in
IDLE DISPLAY.
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to change the value of the digit.
Set RTC Time
This parameter allows you to set the time following the convention selected
in
IDLE DISPLAY.
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to change the value of the digit.
Select the Display Language
This parameter changes the language displayed on the LCD.
Default: ENGLISH
Selections: ENGLISH, SPANISH, FRENCH, GERMAN, ITALIAN,
NORWEGIAN, PORTUGUESE, SWEDISH, DANISH, SPANISH 2,
DUTCH, FINNISH, JAPAN
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 7 • Print Engine Parameters (Page 25 of 25)
Parameter
Action/Explanation
RTS SUPPLY ARM
XXX
IDLE DISPLAY
- FW VERSION +
RTC DATE
- 01/31/01 +
RTC TIME
- 14:55 +
LANGUAGE
- ENGLISH +