User guide

83
Configuration
Control Panel Parameters
6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A
Adjust Left Position
This parameter establishes how far from the left edge of a label the format
begins to print by adjusting horizontal positioning on the label. Positive
numbers adjust the printing away from the main frame by the number of
dots selected; negative numbers shift printing toward the main frame. The
displayed value represents dots.
Default: 0000
Range: –9999 to +9999 dots
To change the value shown:
1. Press the left oval to move the cursor.
2. Press the right oval to change between +/- and to increase the value of
the digit.
3. For a negative value, enter the value before changing to the minus sign.
Set the Printhead Resistor Value
Caution • This parameter should be changed only by qualified service
personnel. Do not set the value higher than that shown on the printhead.
Setting a higher value may damage the printhead.
This value is preset at the factory to match the resistance value of the
printhead. It does not need to be changed unless the printhead or the main
logic board is replaced.
Initial Value: Factory-set to match the printhead shipped with your
print engine.
Default Value: 0500
Range: 0500 to 2000
To set the printhead resistor value:
1. Before replacing the printhead, look for the label that shows the
resistance value (
 value) of the new printhead. Make note of this
setting before installing the new printhead.
2. Press the left oval to move to the next digit position.
3. Press the right oval to increase the value of the digit.
Table 7 • Print Engine Parameters (Page 20 of 25)
Parameter
Action/Explanation
LEFT POSITION
- ±0000 +
HEAD RESISTOR
- 0500 OHMS +