User guide

65
Configuration
Control Panel Parameters
6/29/11 110PAX4/R110PAX4 User Guide 57512L-004 Rev. A
Adjust Backfeed Speed
If backfeed is on, adjusts the speed at which the label backs up before
printing (given in inches per second).
Default: 2 IPS
Range: 1 to 12 IPS
To change the value shown:
1. Press the right oval to increase the value.
2. Press the left oval to decrease the value.
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See Figure 21. Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 21 • Tear-Off Position Adjustment
Default: +0
Range: –120 to +120
To change the value shown:
1. Press the right oval to increase the value. Each press adjusts the tear-off
position by four dot rows.
2. Press the left oval to decrease the value. Each press adjusts the tear-off
position by four dot rows.
Table 7 • Print Engine Parameters (Page 2 of 25)
Parameter
Action/Explanation
BACKFEED SPEED
2 IPS +
TEAR OFF +000
- +
1
Media direction
2
Factory-set tear line location at position 00
1
2