User guide

Operations
Remove Used Ribbon
52
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Remove Used Ribbon
To remove used ribbon, complete these steps:
1. Open the media door.
2. Examine the ribbon. Did the ribbon run out?
If... Then...
Yes a. Remove the empty core from the ribbon supply spindle. Save the core
to use on the ribbon take-up spindle when you load ribbon.
b. Remove the used ribbon and core from the ribbon take-up spindle.
c. Install new ribbon following the instructions in Load Ribbon
on page 46.
No a. Cut the ribbon near the ribbon take-up spindle.
b. Remove the used ribbon and core from the ribbon take-up spindle.
c. Locate an empty ribbon core. If necessary, remove and discard the
used ribbon from the core removed in the previous step.
d. Place the empty ribbon core onto the ribbon take-up spindle, and push
the core toward the print engine frame until it is fully seated.
e. Thread the remaining ribbon on the ribbon supply spindle following
the instructions in Load Ribbon on page 46.