User guide

Print Engine Setup

Connect the Print Engine to a Power Source

6/29/11 110PAX4/R110PAX4 User Guide 57512L-004

Connect the Print Engine to a Power Source

The power supply in the print engine automatically detects the applied line voltage and works

in the 90 to 264 VAC, 47 to 63 Hz range.

The AC power cord must have a three-prong female connector on one end that plugs into the

mating AC power connector at the rear of the print engine. If a power cable was not included

with your print engine, refer to Power Cord Specifications on page 34.

To connect the print engine to a power source, complete these steps:

1. Toggle the print engine power switch to the off (O) position.

2. Plug the power cord into the AC power connector (1) on the rear of the print engine.

3. Plug the other end of the power cord into a power outlet near the print engine.

4. Turn on (I) the print engine.

The control panel LCD and lights activate, indicating that the printer is booting up.

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use an

IEC 320 female connector and the appropriate region-specific three-conductor grounded

plug configuration.

Left-Hand Right-Hand

AC power connector