User guide

Data Ports
Applicator Interface Connector
142
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
11 END PRINT Output See Applicator Signals on page 138 for more information
about the start and end print signals. See Set Applicator
Port Mode on page 84 for more information about the
modes.
Note • A format (^XA ... ^XZ) that does not print
will signal that it is being processed. However, it
will not trigger an End Print signal because no
motion/printing is required.
• MODE 0—The applicator port is OFF.
• MODE 1—Asserted LOW only while the print engine
is moving the label forward; otherwise deasserted
HIGH.
• MODE 2—Asserted HIGH only while the print engine
is moving the label forward; otherwise deasserted
LOW.
• MODE 3—(Default) Asserted LOW for 20
milliseconds when a label is completed and positioned.
Not asserted during continuous printing.
• MODE 4—Asserted HIGH for 20 milliseconds when a
label is completed and positioned. Not asserted during
continuous printing.
12 MEDIA OUT Output Asserted LOW while there is no media in the
print engine.
13 RIBBON OUT Output Asserted LOW while there is no ribbon in the
print engine.
14 DATA READY Output See Applicator Signals on page 138 for more information
about this signal.
• Asserted LOW when sufficient data has been received
to begin processing the next label format.
• Deasserted HIGH when printing/processing stops after
the current label format, either due to a pause condition
or the absence of a label format.
15
(Non-
RFID)
SPARE Output To be determined.
15
(RFID)
VOID Output • Asserted LOW when the RFID transponder over the
antenna is “voided.”
• Deasserted HIGH when the end print signal is asserted.
Table 20 • Applicator Interface Connector Pin Configuration (Continued)
Pin
No.
Signal Name Signal Type Description