User's Manual

Printer Operation
Roll Media Loading
11342L Re v. 8 6/4/2004 105SL User Guide 27
Peel-Only Mode
Refer to Figure 19. The following instructions pertain to printers with the peel option only.
To load media in Peel-Only mode (with or without Rewind option), complete
these steps:
1. Press the printhead open lever. The printhead assembly springs up.
2. Slide out the media supply guide as far from the printer frame as possible.
3. Place the roll of media on the media supply hanger and orient the media properly.
4. Slide in th e media supp ly guide so tha t it just touches, bu t does not restrict, the edge of t he
roll.
5. Feed the media under the inner media guide in the print mechanism.
6. Pull approximat ely 36 in. (915 mm) of media thr ou gh the front of the printer.
7. Ensure that the media is against the inner media guide. Slide in the outer media guide so
that it just touches, but does not restrict, the edge of th e medi a.
8. Close the pr inthead asse mb ly.
9. If your printer has a Peel with a Rewind option, remove the rewind plate and store it
upside-down on the mounting screw on the inside of the front panel.
10. Remove the hook from the peel spindl e shaft.
11. Remove several labels from the media liner and then wi nd the liner once or twice around
the media take -u p spindle.
12. Reinstall the hook on the peel spindle shaft.
Figure 19 • Peel-Only Mode Loading