User's Manual

26 105SL User Guide 6/4/2004 11342L Rev. 8
Printer Operation
Roll Media Loading
Cutter Mode
Refer to Figure 18. The following instructions pertain to printers with the cu tter option only.
To load media in Cutter mode, complete these steps:
1. Open the p r i nthead.
2. Slide the media guide and media supply guide as far from the printer frame as possible.
3. Load media as shown.
4. Slide in the media guide and media supply guide so they just to uch, but do not restrict, the
edge of the roll.
5. Close the printhea d .
6. The printer automatically feeds out and cuts one label when the printer is turned on.
Figure 18 • Cutter Mode Loading
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.