User's Manual

20 105SL User Guide 6/4/2004 11342L Rev. 8
Printer Setup
Ribbon
5. Observe the results. Did the ribbon leave a mark on the paper?
If the ribbon... Then...
Left a mark on the paper The ribbon is coated on the outer surface.
Did not leave a mark on
the paper
The ribbon is l ikely coate d on the inne r surf ace.
a. Flip the rib bon over on the paper so the inner side of t he
ribbon comes in contact with the paper.
b. Scratch the outer surface of the unrolled ribbon with
your fingernail.
c. Lift the ribbon from the paper.
d. Observe the re sul ts again. The ribbon should have left a
mark on the paper. If not, repeat the test, star ting with
the first side again. You may need to scratch the surface
of the ribbon harder.