User's Manual

10 105SL User Guide 6/4/2004 11342L Rev. 8

Printer Setup

Select a Site for the Printer

Consider th e following w hen selecti ng an approp riate locati on for your pr in ter.

Select a Surface

Select a solid, level surface of sufficient size and strength to accommodate the printer and

other equipment (such as a computer), if necessary. The choices include a table, countertop,

desk, or cart.

Provide Proper Operating Conditions

Because the printer was designed and is fabricated as an in dustrial-type un it, it function s

satisfactorily in a location that conforms to specified environmental and electrical conditions,

including a warehouse or factory floor. For more information on the required conditions, see

General Specifications on page 93.

Ta b l e 3 shows the temperature and relative humidity requirements for the printer when it is

operating.

Allow Proper Space

The printer should have enough space around it for you to be able to open the media door. To

allow for proper ventilation and cooling, leave open space on all sides of the printer.

Provide a Data Source

If the printer will be located away from the data source, the selected site must provide the

appropriate connections to that data source. For more information on the types of

communication interface s, see Select a Communication Interface on page 13.

Table 3 • Operating Temperature and Humidity

Mode Temperature Relative Humidity

Thermal Transfer 41° to 104°F (5° to 40°C) 20 to 85% non-condensing

Direct Thermal 32° to 104°F (0° to 40°C) 20 to 85% non-condensing

Caution • Do not plac e any padding o r cushioning material behind or un der the pr inter

because this restricts air flow and could cause the printer to overheat.