Specifications
Page 4-12 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
5HFRQQHFWLQJDQG3RZHULQJWKH3ULQWHU
Parallel Data Cable: To install the parallel data cable, push the 36-pin parallel data cable male
connector into the parallel data port connector. Firmly seat the connector. Secure the
connector with the two wire retainers.
Serial Data Cable: If an adapter was connected to the serial data port, reinstall the adapter
and secure it with the two screw fasteners. To install the serial data cable, push the serial data
cable male connector into the serial data port connector or adapter. Firmly seat the connector.
Secure the connector with the two screw fasteners.
To install the power cord, line up the female connector with the printer power socket and push
the connector fully into the socket. Ensure that the power switch is in the Off (O) position and
plug the power cord into a live AC outlet.
Place the power switch in the On (I) position.
5531R5HPRYHDQG,QVWDOOWKH(OHFWURQLFV&RYHU
Refer to Figure 4-8. To remove the electronics cover, remove the two screws located near the
bottom. Lift electronics cover at the rear top corner as shown and pull the corner forward and
up. Lift the cover up and away from the printer.
To install the cover, be careful not to pinch your fingers, and lower the cover so the lip goes into
the channel on the top of the printer.
Figure 4-8. Removing and Installing the Electronics Cover
Electronics Cover
(Left Hand Side)
Liftupat
rear corner
Screws
Channel
Lip of Cover