Specifications

Page 4-10 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 4 PREVENTIVE AND CORRECTIVE MAINTENANCE
5RXWLQH5HIHUUDO3URFHGXUHV553
Routine Referral Procedures are commonly used steps that are performed often during
corrective maintenance. These procedures are referenced throughout this section of the
manual.
5531R3UHSDULQJ3ULQWHUIRU0DLQWHQDQFH
Removing Power and Disconnecting the Printer
Refer to Figure 4-6. Power switch position (I) is the On position. Switch position (O) is the Off
position. Place the power switch in the Off (O) position.
Remove the power cord from the power source. Grasp the plug of the power cord and pull it
straight away from the printer.
Refer to Figure 4-7. Parallel Data Cable: Pry off wire retainers from the parallel data cable
connector. Pull the data cable connector away from the parallel data port connector. Serial
Data Cable: Loosen the two screw fasteners from serial data cable connector and pull it away
from serial data port connector. If there is an adapter connected to the serial data port, remove
the adapter.
Figure 4-5. Interconnection Diagram for Printer Configurations 10500-2XXX-XXXX and
10500-3XXX-XXXX
Cutter
Option
Front Panel
Interface
LCD
Display
Lower
Media
Sensor
Ribbon
Sensor
Head Open
Sensor
Printhead
Data
Black Mark
Sensor
Lower
Take-Label
Sensor
Upper
Take-Label
Sensor
Upper
Media
Sensor
Stepper
Motor
MAIN LOGIC
PCB
PCMCIA
OPTION
BOARD
AC/DC
POWER
PCB
Printhead
Power
AC
Input
AC
Power
Fuse
Main Logic
Board
Power
Cutter
Option
P6
P25
P27
P8
P2
P1
P3
P32
P31
P19
P5
P10