Specifications

Page 2-48 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 2 OPERATION OVERVIEW
3&0&,$&$5',167$//$7,21
The PCMCIA card slot is a factory installed option. If your printer has that option, you may
install or change the card at any time. Use the following procedure to install a PCMCIA card.
CAUTION:
OBSERVE PROPER ELECTROSTATIC SAFETY PRECAUTIONS WHEN
HANDLING ANY STATIC-SENSITIVE COMPONENTS SUCH AS PRINTED
CIRCUIT BOARDS AND PRINTHEADS.
1. Place the power switch in the Off (O) position and disconnect the AC power cord.
Disconnect the data cables.
2. Refer to Figure 2-31 and remove and retain the screw and the option card shield from
the rear of the printer.
3. If you are replacing the card, press the card eject button and slide the card out of the
slot.
4. Slide the new card into the slot far enough that the eject button pops out.
5. Reinstall the option card shield and secure it with the screw.
6. Reconnect the AC power cord and all data cables.
7. Hold in the FEED key while placing the power switch in the On (I) position.
8. Verify the presence of additional memory or optional fonts by checking the information
on the configuration label printed during the power on sequence.
9. The printer is now ready to operate with the additional memory or font option.
Figure 2-31. Installing PCMCIA Card
Card Eject
Button
PCMCIA
Card
Option Card
Shield