Specifications

Page 2-46 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 2 OPERATION OVERVIEW
6HWWLQJWKH)RUPDW&RQYHUW
This parameter selects the bitmap scaling factor. The first number is the original dots per
inch (dpi) value; the second, the dpi to which you would like to scale.
Press the right or left oval key to display other choices.
Default: None
Selections: None, 150 → 300, 150 → 600, 200 → 600, 300 → 600
Press the NEXT key to display IP Resolution.
,35HVROXWLRQ
Depending on the selection allows either the user (“permanent”) or the server (“dynamic”) to
select the IP address. For more information, refer to ZebraNet Networking: PrintServer ll
Installation and the User’s Guide for this printer.
Press the right or left oval key to display other choices.
Default: Dynamic
Selections: Dynamic, Permanent
Press the NEXT key to display IP Address.
,3$GGUHVV
This parameter allows you to select the IP address if “permanent” was chosen in “IP
RESOLUTION.” (If “dynamic” was chosen, the user cannot select the address.) For more
information, refer to ZebraNet Networking: PrintServer II Installation and User’s Guide.
Press the left oval key to move to the next digit position, press the right oval key to increase
the value of the digit.
Press the NEXT key to display SUBNET MASK.
 )250$7&219(57
← 121( →
 ,35(62/87,21
← '<1$0,& →
,3$''5(66
