Specifications
32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 2-41
OPERATION OVERVIEW SECTION 2
7KH'HOLPLWHU&KDUDFWHU
The delimiter character is a two-digit hex value. Once configured, this character acts as a
parameter place marker in ZPL/ZPL II. Refer to the “ZPL II Programming Guide” for more
information.
Press the left oval key to move to the next digit position, and press the right oval key to
increase the value of the digit. (The displayed “H” is not entered as part of the value.)
Default: 2C (comma)
Range: 00 – FF (exclude the values indicated on the ASCII Code Chart.)
Press the NEXT key to display MODE.
6HOHFWLQJ=3/0RGH
The printer accepts label formats written in either ZPL or ZPL II. Refer to the “ZPL II
Programming Guide” for more information on the differences between ZPL and ZPL II.
The printer remains in the selected mode until changed by this front panel instruction or by
sending the ^SZ ZPL/ZPL II command to the printer.
Press the right or left oval key to display other selections.
Default: ZPL II
Selections: ZPL II, ZPL
Press the NEXT key to display MEDIA POWER UP.
32:(583$1'+($'&/26(3$5$0(7(56
0HGLD3RZHU8S
Turning on the printer determines the action of the media. “Calibration” recalibrates the
media and ribbon sensors, “Feed” feeds the label to the first web, “Length” calculates the
length of the label, and “No Motion” means the media does not move.
Press the right or left oval key to display other selections.
Default: Calibration
Selections: Feed, Calibration, Length, No Motion
'(/,0,7(5&+$5
→!&+
=3/02'(
←=3/,,→
0(',$32:(583
←&$/,%5$7,21→