Specifications
Page 2-36 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 2 OPERATION OVERVIEW
0HGLDDQG5LEERQ6HQVRU&DOLEUDWLRQ
NOTES: Before you begin this procedure, make sure that the maximum length is
set to a value greater than the length of the labels are using. If the
maximum length is set to a lower value, the calibration process assumes
that continuous media is in the printer.
Ensure that the “Media Type” and “Maximum Length” values have been
configured prior to performing this calibration process.
Press (+) to perform calibration.
Refer to “CALIBRATION” on page 2-24 for further details.
6HWWLQJ&RPPXQLFDWLRQ3DUDPHWHUV
Communication parameters must be set correctly for the printer to receive data from the
host. These parameters ensure that the printer and host are “speaking the same language.”
All communications parameters are password protected.
6HWWLQJ3DUDOOHO&RPPXQLFDWLRQV
Select the communications port that matches the one being used by the host computer.
Press the right or left oval key to display other selections.
Default: Parallel
Selections: Parallel, Twinax/Coax
6HWWLQJ6HULDO&RPPXQLFDWLRQV
Select the communications port that matches the one used by the host computer.
Press the right or left oval key to display other choices.
Default: RS232
Selection: RS232, RS422/485, RS485 Multidrop
Press the NEXT Key to display BAUD rate.
0(',$$1'5,%%21
&$/,%5$7(
3$5$//(/&200
←3$5$//(/→
6(5,$/&200
←56→