Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 2-35
OPERATION OVERVIEW SECTION 2
3. Press the right oval key “YES” to begin initialization, or, press the left oval key “NO” to
cancel the request and return to the “INITIALIZE FLASH” prompt.
4. Press the SETUP/EXIT key followed by the NEXT/SAVE key. If initialization is still in
process, the display flashes back and forth between the two phrases “CHECKING E:
MEMORY” and “PRINTER IDLE.”
5. When initialization is complete, the printer automatically exits the configuration mode
and the display shows “PRINTER READY.”
NOTE: Depending on the amount of free Flash memory, initialization may take up
to one minute to complete.
6HQVRU3URILOH
Press the right oval key to print a graphic representation (Media Sensor Profile) of the
changes in density between the media and the web (backing). Use the Sensor Profile to
help troubleshoot media registration problems.
Refer to Figure 2-27. The Media Sensor Profile shows three conditions. The black area
along the bottom of the profile illustrates media passing by the media sensor. When the level
goes above the point labeled “WEB” (black spikes), only the backing material is passing by
the sensor. When a notch or hole in the media passes by the sensor, the level goes above
the point labeled “MEDIA”. If the level remains above the “MEDIA” point for longer than
0.5 seconds, this signifies a Media Out condition. The Ribbon Profile indicates Ribbon IN if
the black level is above the point labeled “RIBBON”.
Press the NEXT key to display MEDIA AND RIBBON.
6(1625352),/(
35,17
Figure 2-27. Sensor Profile Sample Label