Specifications
Page 2-30 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 2 OPERATION OVERVIEW
6HOHFWLQJWKH3ULQW0HWKRG
The Print Method parameter specifies the method of printing: direct thermal (no ribbon) or
thermal transfer (using thermal-transfer media and ribbon).
Press the right or left oval key to display other selections.
Default: Thermal Transfer
Selections: Thermal Transfer, Direct Thermal
Press the NEXT key to display PRINT WIDTH.
6HWWLQJWKH3ULQW:LGWK
Print width selects the media width. Setting the width too narrow may result in portions of your
label not being printed on the label material. In addition, the setting can affect the horizontal
position of the label format if you invert the image via the ^POI ZPL II command. Setting the
width too wide wastes formatting memory and can cause printing to occur on the platen to the
side of the actual label.
The units of measure can be changed from millimeters to inches to dots. Inches and
millimeters are shown as fractions of the dots per inch (for example, 4 101/203 is the value
for 4-1/2″).
Press the right oval key to increase the value or change the unit of measure and press the
left oval key to change the selected character position. Select a print width that is at least as
wide as your media.
Default; Range: Print width determines the printable area across the width of the
label.
Press the NEXT key to display MAXIMUM LENGTH.
CAUTION:
Selecting direct thermal when using thermal transfer media and
ribbon results in an error message, but printing continues. If the print
method is not changed to thermal transfer or if the media is not
changed, damage to the printhead may result.
35,170(7+2'
7+(50$/–75$16
35,17:,'7+
→ 0