Specifications
Page 2-28 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 2 OPERATION OVERVIEW
NOTE: The feed key self test described in “troubleshooting” can also be used to
determine the best darkness setting.
If printing is too light, you should increase the darkness. If printing is too dark, or if there is
spreading or bleeding on printed areas, you should decrease the darkness. If there are voids
in printed areas, adjust the toggle pressure.
NOTE: The darkness setting takes effect right away. If labels are being printed,
results can be seen immediately.
Press the right oval key to increase darkness, or press the left oval key to decrease
darkness.
Default: +10
Range: 0 to +30
Press the NEXT key to display TEAR OFF.
6HWWLQJWKH7HDU2II3RVLWLRQ
The Tear-Off position adjusts the position of the media over the peel bar after printing.
Press the right oval key to increase the value or the left oval key to decrease the value.
Each press of the key moves the tear-off position by four dot rows (positive values move the
media farther out over the peel bar).
Default: +0
Range: –120 to +120
Press the NEXT key to display PRINT MODE.
CAUTION:
Set the darkness to the lowest setting possible for the desired print
quality. Setting darkness too high for a given ribbon may cause ink
smearing and/or printhead burning through the ribbon.
'$5.1(66
–
7($52))
–