Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 2-15
OPERATION OVERVIEW SECTION 2
0HGLD5HZLQG0RGH³IRU3ULQWHUV:LWKRXWWKH&XWWHU2SWLRQ
NOTE: Media rewind option required.
Refer to Figure 2-16.
1. Remove the rewind plate from its storage location in front of the print mechanism inside
the media compartment.
2. Invert the rewind plate so that the lip on the attached hook plate points down.
3. Insert the hook plate lip approximately 1/2
″ (15 mm) into the lower opening in the side
plate.
4. Align the upper end of the rewind plate with the corresponding opening in the side
plate. Slide in the rewind plate so that it stops against the printer’s main frame.
5. Open the printhead.
6. Slide the media guide and media supply guide as far from the printer frame as possible.
7. Load media as shown.
8. When loading media, allow approximately 36″ (915 mm) of media to extend past the
printhead. Remove all labels from this portion to create a leader.
Figure 2-15. Peel and Liner Rewind Loading
Media
guide
Media
Media
supply
guide
Closed
Open
Rewind
spindle
Hook
Rewind
plate
Tear-off/
peel-off
bar
Guide
plate
L
abel
Label
backing