Specifications
32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 2-3
OPERATION OVERVIEW SECTION 2
)URQW3DQHO,QGLFDWRUV
For an explanation of the front panel indicators, refer to the following table and to Figure 2-1.
NOTE: If two operating conditions occur simultaneously (for example, one that
causes a light to be on constantly and one that causes the same light to
flash), the light flashes.
Table 2-2. Front Panel Lights
Light Status Indication
Power—green Off The printer is off or power is not applied.
On
The printer is on.
Take Label—green Off Normal operation.
Flashing
NOTE: Peel-off mode only. The label is available. Printing is paused
until the label is removed.
Error—yellow Off Normal operation — no printer errors.
Flashing
A printer error exists. Check the display screen for more information.
Check Ribbon—yellow Off Normal operation — ribbon, if used, is properly loaded.
On
The front panel displays a warning message.
If the printer is in direct thermal mode: Ribbon is loaded, but the printer
continues printing.
If the printer is in thermal transfer mode: No ribbon is loaded. The printer
is paused and the PAUSE light is on.
Paper Out—yellow Off Normal operation — media is properly loaded.
On
No media is under the media sensor. Printing is paused, the display
shows an error message, and the PAUSE light is on.
with yellow light
Off Normal operation.
On
The printer has stopped all printing operations. Either the PAUSE key was
pressed, a pause command was included in the label format, or a printer
error was detected. Refer to the display screen for more information.
with green data light
Off Normal operation.
On
Data processing or printing is taking place.
When in the pause mode, this key cancels print jobs.
• Print job in queue: press once for each print job to be deleted.
Press and hold for several seconds to cancel all print jobs in the printer’s
memory. The green DATA light turns off.
Flashing
The printer is receiving data from or sending status information to the host
computer. Flashing slows when the printer cannot accept more data, but
returns to normal once data is again being received.
3$86(