Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-27
OPTION KITS SECTION 6
6. Dress the ribbon cable behind the twinax interface board as you slide the board
completely into the printer.
7. Fasten the twinax interface board in place with the two screws used for the blank cover.
8. Reinstall the electronics cover.
9. Refer to Figure 6-23. Connect the 9-pin twinax adapter cable connector to the mating
connector on the interface board.
10. Connect the twinax cable from the host computer to the mating connector on the
adapter cable.
NOTE: After setting the DIP switches, turn the printer power off (O) and back
on (I). With the exception of DIP switch number 2, the printer monitors the
positions of the DIP switches only during the Power-On Self Test (POST).
The EBCDIC buffer print function is enabled whenever DIP switch
number 2 is placed in the “Right” position.
11. Refer to Table 6-5. Set the dip switches in the correct position for this application.
12. Reconnect the power cord and the data cables to the printer.
13. Reconnect the power cord to the power source. Place the power switch in the On (I)
position.
14. Ensure the printer configuration is set as shown in Table 6-6.
15. Send a sample label format from the host computer to the printer to test for proper
operation.
Figure 6-22. Twinax Interface Board Installation (Printer Configurations
10500-2XXX-XXXX and 10500-3XXX-XXXX)
Interface
Board
Data
Cable
Connector
Interface
Data
Cable