Specifications
Page 6-20 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
(;7(51$/=(%5$1(735,176(59(5 ,,237,21
External ZebraNet PrintServer II (part # 46692), as shown in Figure 6-17, plugs directly into
the printer’s parallel port. Use the following procedure to install and test the ZebraNet
PrintServer II.
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Attach the PrintServer II device directly into the parallel port on the printer. Secure the
PrintServer II to the printer with the wire clips.
3. Insert an active 10BaseT cable into the Ethernet connector on the back of the
PrintServer II device.
4. Reconnect the power cord to the printer.
Figure 6-15. Internal PrintServer ll Installation (Printer Configurations
10500-0XXX-XXXX and 10500-1XXX-XXXX)