Specifications
Page 6-16 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
,17(51$/)$1)2/'6833/<%,1237,21
This kit (part # 40457) includes the parts necessary to install the internal fanfold supply bin
option into the 105SL. Use the following procedure to install the internal fanfold supply bin.
NOTE: The Internal Fanfold Supply Bin cannot be installed in a printer that
contains a Media Rewind Option or a Peel-off Option.
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover. Open the printhead and remove media from the machine.
3. Clean all paper dust and scraps from the base of the printer.
4. Attach the fanfold supply bin to the base of the printer with the three supplied screws,
flat washers, and nuts, as shown in Figure 6-13.
5. Position and install the fanfold media into the supply bin.
6. Install the side bracket and end bracket into the fanfold supply bin. Adjust the side and
end brackets to accommodate the media size; close but not touching the media.
Figure 6-11. Cutter Catch Tray Installation