Specifications
32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-15
OPTION KITS SECTION 6
3. Press (+) or (–) key until you select REWIND.
4. Pressing the Setup/Exit key to leave the Configuration mode. Press the (+) or (–) key to
select Permanent. Press Next/Save to accept and make permanent.
$GMXVWLQJWKH3ODWHQ6XSSRUW%UDFNHW
If the liner is tracking off to one side, perform the following procedure to position the roller
adjust plate.
1. Refer to Figure 6-7. Loosen, but do not remove, the two screws holding the platen
support bracket to the side plate.
NOTE: Moving the bracket toward the front of the machine moves the media
toward the main frame. Moving the bracket toward the rear of the machine
moves the media away from the main frame.
2. Adjust the bracket position as required and tighten the screws.
3. Tighten the two screws. Check label backing tracking again.
4. Repeat the procedure until the required results are achieved.
&877(5&$7&+75$<237,21
This kit (part # 48459) includes the parts necessary to install the cutter catch tray option into
the 105SL. Use the following procedure to install the cutter catch tray.
1. Refer to RRP No. 1 on page 4-10 and place the power switch in the Off (O) position
and disconnect the AC power cord. Disconnect the data cables.
2. Open the media cover.
3. Refer to Figure 6-11. If your printer has no factory options but does have a field
installed cutter, use the front cover bracket that comes with the printer.
4. If your machine has a cutter, but you want to print and rewind, disable the cutter and
use the rewind plate as shown in Figure 6-10.
5. Hook the catch tray over the front of the printer. Make sure the two slots in the tray
engage behind the front cover bracket. Connect the catch tray to the cutter by
engaging the two locating tabs.
6. Tighten the two thumb nuts to secure the tray to the printer.
NOTE: The adjusting nuts on the back of the catch trays allow the trays and
guide stops to be adjusted for length and width.
7. Refer to Figure 6-12. Adjust the length of the assembled upper and lower catch trays
for the length of labels being printed and cut.
8. Adjust the catch tray for the width of labels being printed.
9. Close the media cover.
10. Reconnect the power cord to the printer.
11. Reconnect the power cord to the power source. Place the power switch in the On (I)
position. The printer is ready to print, cut, and catch labels.