Specifications

Page 6-14 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
NOTE: Figure 6-4 illustrates 105SL printers with configuration numbers
10500-0XXX-XXXX and 10500-1XXX-XXXX. Figure 6-5 illustrates 105SL
printers with configuration numbers 10500-2XXX-XXXX and
10500-3
XXX-XXXX.
33. Refer to Figure 6-4 or Figure 6-5. Route the sensor wires through the cable clamps and
bring them to the main logic board. Make sure that the wires do not come in contact
with any moving parts.
34. Connect the sensor connectors to the main logic board as shown.
NOTE: In peel off mode, if the two sensors are not aligned with each other, the
take label LED illuminates, and the printer does not operate.
35. Refer to RRP No. 9 on page 4-23 and remove the main drive belt.
36. Refer to Figure 6-6. Route the rewind drive belt around the inside stepper motor pulley,
rewind spindle pulley, rewind platen pulley and the idler pulley.
NOTE: The rewind assembly may reach the limit of travel before the belt is tight.
37. Slide the rewind assembly toward the rear of the printer until the belt tension is tight.
Extend the Allen wrench through the access holes in the backing take-up pulley
assembly, and tighten the three screws.
38. Grasp the idler pulley and shaft assembly. Loosen the screw securing the idler pulley,
and slide the assembly toward the rear of the printer until belt tension is tight. Tighten
the screw to secure the idler pulley.
39. Hook a spring scale at the midpoint of the lower section of the belt and pull up. The belt
should deflect 0.25 inches with a tension of 2000 grams (4.5 lbs.). If necessary, adjust
the belt tension by changing the position of the idler pulley.
40. When adjustment is completed, reinstall the plastic plug in the lower access hole in the
print mechanism side plate.
41. Reinstall the main drive belt. Refer to RRP No. 8 on page 4-22 and adjust the tension
on the main drive belt.
42. Reinstall the DC power supply or the AC/DC power supply, depending on configuration.
43. Reinstall the electronics cover.
44. Reinstall the media and ribbon.
45. Reconnect the data cables and the power cord.
46. Reconnect the power cord to the power source. Place the power switch in the On (I)
position.
47. Perform a PAUSE Key Self Test and observe the tracking of the liner. If the liner does
not track properly, proceed to “Adjusting the Roller Adjust Plate.”
5HFRQILJXUHWKH3ULQWHUIRU5HZLQG2SHUDWLRQ
1. Enter the Configuration mode by pressing the Setup/Exit key at the Printer Ready
display.
2. Press Next/Save until you get to Print Mode.