Specifications

32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-13
OPTION KITS SECTION 6
23. Slide spacer (21) onto the platen roller.
NOTE: Use part # 30257 for 300-dpi printers or part # 48018M for 203-dpi printers.
24. Slide rewind platen pulley (17) onto the platen roller and align the two set screws with
the flat surfaces of the platen roller.
25. Leave approximately a 0.020 (0.5 mm) gap between the C-ring and platen support
bracket. Tighten the two pulley set screws.
26. Refer to Figure 6-10 and engage the top lip and hook plate of the rewind plate into the
two mounting slots.
27. Slide the plate in as far as it can go.
28. Remove the plastic plugs from the upper and lower take-label sensor mounting holes.
NOTE: The upper take-label sensor has green/yellow wires.
29. Refer to Figure 6-3. Insert the upper take label sensor connector and cable through the
upper hole in the main frame.
30. Position the sensor with the window facing down. Secure the sensor to the main frame
with one screw.
NOTE: The lower take-label sensor has black/red wires.
31. Insert the lower take label sensor connector and cable through the lower hole in the
main frame.
32. Position the sensor with the window facing up. Secure the sensor to the main frame
with one screw.
Figure 6-10. Rewind Plate Installation
Rewind Plate
Lip
Adjustable
Hook Plate
Slot