Specifications

Page 6-12 105SL Maintenance Manual 32056L Rev. 2 12/4/01
SECTION 6 OPTION KITS
6. Place a flat washer (2) onto one of the screws (8). Using the Allen wrench provided
with this kit, place this mounting screw through the lower access hole in the side plate
and through the idler pulley mounting slot in the printer main frame. On the electronics
side of the printer main frame, attach the idler shaft (22) to the mounting screw.
7. Position the idler shaft in the middle of the mounting slot and tighten the mounting
screw.
NOTE: Avoid getting grease anywhere except on the idler shaft.
8. With a toothpick or small screwdriver, apply a very small amount of grease (provided in
kit) to the idler shaft.
9. Orient the idler pulley (20) as shown, and slide it onto the idler shaft.
10. Remove and discard the plastic plug from the rewind spindle mounting hole near the
bottom of the side plate.
11. Slide the bearing housing assembly (11) off the shaft of the backing rewind spindle
assembly (5).
12. Install the bearing housing assembly on the printer main frame using three screws (1)
and three flat washers (2). Do not tighten the screws at this time.
13. Insert the shaft of the rewind spindle (5) through the bearing housing assembly.
14. Place the wave washer (16), flat washer (15) and pulley (12) over the rewind spindle
shaft.
15. Slide the spacer (23) onto the rewind spindle shaft. Press the E-ring (13) into the
groove in the rewind spindle shaft.
16. Attach the platen support bracket (7) to the side plate with two flat washers (2) and two
screws (8). Do not tighten the screws at this time.
17. Remove and discard the plastic plug from the rewind platen mounting hole near the
bottom of the side plate.
18. Insert the long end of the platen roller (4) through the platen mounting hole.
19. Place one flange bearing (3) over the left end of the platen roller, flange out. Press the
bearing into the mounting hole of the main frame.
20. Place the opposite end of the platen roller through the platen support bracket.
21. Place the remaining flange bearing (3) over the right end of the platen roller with the
flange of the bearing facing the outside of the platen support bracket. Press the bearing
into the mounting hole in the platen support bracket and secure with the C-ring (9).
22. Tighten the mounting screws that secure the platen support bracket to the side plate.
The bracket may need adjustment later.
WARNING:
WEAR PROTECTIVE EYE WEAR WHEN REMOVING E-RINGS, C-CLIPS,
SNAP RINGS AND SPRINGS. ALL OF THESE ARE UNDER TENSION AND
COULD FLY OFF WHILE BEING REMOVED.