Specifications
32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 6-9
OPTION KITS SECTION 6
3. Tighten the two screws. Check label backing tracking again.
4. Repeat the procedure until the required results are achieved.
0(',$5(:,1'237,21.,7
This kit (part # 33181) includes the parts necessary to install the media rewind option into the
105SL. The kit includes all the parts listed in Table 6-2 and shown in Figure 6-8.
* Only available in quantities of 25 as Part Number HW30393-006
** Only available in quantities of 25 as Part Number HW40193
*** Only available in quantities of 50 as Part Number HW30392-004
† Only available in quantities of 25 as Part Number HW30118
†† Only available in quantities of 25 as Part Number HW30114
††† Only available in quantities of 25 as Part Number HW30115
‡
Only available in quantities of 100 as Part Number HW07435
Table 6-2. Media Rewind Option Kit
3
Item # Qty Part Number Description
13 Screw, 8-32 × 0.37, Socket Head Cap
26 Washer, Flat 0.406 x 0.172 x 0.048
32 Bearing, Flanged (Part of 40038M)
41 Platen Roller
515 Backing Rewind Spindle
6147062-2 Hook, Rewind
7140019 Bracket, Platen Support
83 Screw, 6-32 x 0.25
9202252 C-Ring
10 1 Assembly, Std. Rewind Plate
11 1 Assembly, Bearing Housing (Part of 40055R)
12 1 31336M Kit, Maintenance, RTU/MTU Pulley
13 1
† E-Ring
14 1 45189-2 Belt, Rewind Drive
15 1
†† Washer, Flat 0.76 x 0.51 x 0.03
16 1
††† Washer, Wave
17 1
30257 Pulley, Rewind (12 Dot/mm, 300 dpi)
48018M Pulley, Rewind (8 Dot/mm, 203 dpi)
18 1
46609-4M Assembly, Lower Take Label Sensor. (Black/Red Wires)
Assembly Upper Take Label Sensor. (Green/Yellow Wires)
19 2 ‡ Screw, 6-32 x 0.37
20 1 30265 Pulley, Idler
21 1 Spacer (Part of 40038M)
22 1 30207 Shaft, Idler
23 1 Spacer (Part of 31336M)
24 1 11301 Wrench, Long Allen, 7/64
″
N/S 1 Grease (Lubriplate GR-132)
(N/A) – Not Available as a Separate Service Item N/S – Not Shown
Bold = Part available for purchase
Light italic = Part not available for purchase, listed and shown for reference only